Skip to main content

JUNG HOME Wall Switch

Note: The mentioned product is not a HÄFELE product, therefore HÄFELE has no influence on the functionality of the hardware or firmware. Possible firmware updates can only be done via the manufacturer's app.

Warning: The mentioned product requires a 220V power supply and should only be operated by trained electrical professionals.

A JUNG HOME permanent current wall switch always consists of two parts: the system insert for installation in the wall box and the attachment. So far, the following combinations are supported by the Connect Mesh App:

2-way switch + auxiliary system insert 2-way switch + relay system insert 1-way switch + auxiliary system insert 1-way switch + relay system insert

The following functions are currently supported: Switching on/off Dimming up/down Increasing/decreasing light temperature Primary functions: Short press or long hold Calling up scenes Relay control (only with relay system insert)

The following functions are currently NOT supported: Changing the status LEDs on the front Secondary functions Individual key assignment

In the delivery state, the device should initially be in provisioning mode after being connected to the power supply. To set up in the Connect Mesh App, switch to setup mode and search for new devices. If the device is not found, it must first be reset (see below).

After successful provisioning, the left and right rocker can be individually configured to control rooms, groups or individual devices or to trigger scenes.

JUNG 2-way Switch

Reset​

The device is reset to provisioning mode as follows: Hold the upper and lower left buttons simultaneously for >20 seconds until the LEDs start flashing red quickly Now release both buttons and press SHORT again. The status LED flashes red slowly for about 5 seconds, the device is reset to factory settings. If this does not work, disconnect the device from the power supply again, reconnect it and repeat the two steps above.

JUNG HOME 1-way Switch

Reset​

The device is reset to provisioning mode as follows: Hold the upper and lower buttons simultaneously for >20 seconds until the LEDs start flashing red quickly Now release both buttons and press SHORT again. The status LED flashes red slowly for about 5 seconds, the device is reset to factory settings.

For more information, please visit the JUNG website.