JUNG HOME SCHUKO Socket

Note: The mentioned product is not a HÄFELE product, therefore HÄFELE has no influence on the functionality of the hardware or firmware. Possible firmware updates can only be done via the manufacturer's app.

Warning: The mentioned product requires a 220V power supply and should only be operated by trained electrical professionals.

A JUNG HOME SCHUKO socket can remotely control the connected load. In the upper right corner, there is a button to manually control the socket.

The following functions are currently supported: Switching on/off

The following functions are currently NOT supported: Changing the status LEDs on the front Energy meter function

In the delivery state, the device should initially be in provisioning mode for the first 2 minutes after being connected to the power supply. To set up in the Connect Mesh App, switch to setup mode and search for new devices. If the device is not found, it must first be reset (see below).

After successful provisioning, the left and right rocker can be individually configured to control rooms, groups or individual devices or to trigger scenes.

Reset

The device is reset to provisioning mode as follows: Hold the upper right button for >20 seconds until the LED starts flashing red quickly Now release the button and press SHORT again. The status LED flashes red slowly for about 5 seconds, the device is reset to factory settings. If this does not work, disconnect the device from the power supply again, reconnect it and repeat the two steps above.

For more information, please visit the JUNG website.